Service graphs
Graph Information
This graph shows the value of all S.M.A.R.T attributes of drive sdb (Maxtor 7L300R0). smartctl_exit_status is the return value of smartctl. A non-zero return value indicates an error, a potential error, or a fault on the drive.
Field | Internal name | Type | Warn | Crit | Info |
---|---|---|---|---|---|
Calibration_Retry_Count | Calibration_Retry_Count | gauge | 223: | ||
Current_Pending_Sector | Current_Pending_Sector | gauge | 000: | ||
Data_Address_Mark_Errs | Data_Address_Mark_Errs | gauge | 000: | ||
Hardware_ECC_Recovered | Hardware_ECC_Recovered | gauge | 000: | ||
Load_Cycle_Count | Load_Cycle_Count | gauge | 000: | ||
Multi_Zone_Error_Rate | Multi_Zone_Error_Rate | gauge | 000: | ||
Offline_Seek_Performnce | Offline_Seek_Performnce | gauge | 000: | ||
Offline_Uncorrectable | Offline_Uncorrectable | gauge | 000: | ||
Power_Cycle_Count | Power_Cycle_Count | gauge | 000: | ||
Power_Off_Retract_Count | Power_Off_Retract_Count | gauge | 000: | ||
Power_On_Minutes | Power_On_Minutes | gauge | 000: | ||
Read_Channel_Margin | Read_Channel_Margin | gauge | 100: | ||
Reallocated_Event_Count | Reallocated_Event_Count | gauge | 000: | ||
Reallocated_Sector_Ct | Reallocated_Sector_Ct | gauge | 063: | ||
Run_Out_Cancel | Run_Out_Cancel | gauge | 180: | ||
Seek_Error_Rate | Seek_Error_Rate | gauge | 000: | ||
Seek_Time_Performance | Seek_Time_Performance | gauge | 187: | ||
Soft_ECC_Correction | Soft_ECC_Correction | gauge | 000: | ||
Soft_Read_Error_Rate | Soft_Read_Error_Rate | gauge | 000: | ||
Spin_Buzz | Spin_Buzz | gauge | 000: | ||
Spin_High_Current | Spin_High_Current | gauge | 000: | ||
Spin_Retry_Count | Spin_Retry_Count | gauge | 157: | ||
Spin_Up_Time | Spin_Up_Time | gauge | 063: | ||
Start_Stop_Count | Start_Stop_Count | gauge | 000: | ||
Temperature_Celsius | Temperature_Celsius | gauge | 000: | ||
Thermal_Asperity_Rate | Thermal_Asperity_Rate | gauge | 000: | ||
UDMA_CRC_Error_Count | UDMA_CRC_Error_Count | gauge | 000: | ||
Unknown_Attribute | Unknown_Attribute | gauge | 000: | ||
smartctl_exit_status | smartctl_exit_status | gauge | 1 |